Skil PR0601B-00 Owner's Manual page 19

Lubricating the Saw Chain
(Fig. 13)
Chain life and cutting
NOTICE
performance depend on proper
lubrication. Therefore, the chain should be oiled
before operation.
NOTE: Bar and chain oil is not included and
must be purchased separately.
WARNING
the pruning saw. Oil may spill and cause a fire.
a. Switch off the pruning saw and remove the
battery.
b. Place the pruning saw on a level surface with
the housing cover facing up.
c. Clean the guide bar and chain with a soft
brush or solvent if necessary.
d. Apply one drop of oil (not included) in the
area between guide bar and chain (Fig. 13).
Apply additional drop of oil after every 10
cuts.
e. Attach the battery pack and turn the pruning
saw on for a few seconds. This will evenly
distribute the oil.
f. In addition, the guide bar has a built-in
sprocket at its tip. The sprocket must be
lubricated weekly with an oil dispensing
bottle to extend the sprocket life. Use an
oil dispensing bottle to lubricate weekly by
means of the lubricating hole on each side of the bar.
NOTICE
Never use oil or other lubricants not specifically designed for use on the bar and chain. This
•
can lead to a clogged oil system, which may cause premature wear of the bar and chain.
Do not use dirty, used, or otherwise contaminated oil. Damage may occur to the bar or chain.
•
Do not smoke or bring any
fire or flame near the oil or
Fig . 12
Lock-off Button
BRUSHLESS
Trigger Switch
Fig . 13
Lubricating Hole
19