Audi RS 7 Sportback 2016 Owner's Manual page 92

Table of Contents

Advertisement

Audi
active
lane
assist
White line(s)
Active lane assist is activated
and ready to provide warnings.
Red line(s)
Active lane assist warns you
(left or rig ht)
before leaving a lane ¢ fig . 99.
In addition, the steering wheel
vibrates lightly.
Gray line(s)
Active lane assist is activated,
but not ready to give warning
¢ fig.
100.
Messages in the instrument cluster display
If the active lane assist switches off automatical-
ly, the indicator light in the display turns off and
one of the following messages appears:
Audi active lane assist: Currently unavailable.
No camera view
This message appea rs if the came ra is unable to
detect the lines. This could happen if:
- The camera field of view ¢ page 89, fig . 98 is
dirty or covered in ice. Clean this area on the
windshield.
- The camera field of view is fogged over . Wait
until the fog has cleared before switching the
active lane assist on again.
- The system has been unable to detect the lanes
for an extended period of time due to road con-
ditions. Switch the active lane assist back on
when the lines are more visible .
Audi active lane assist: currently unavailable
There is a temporary active lane assist malfunc-
tion . Try sw itching the act ive lane assist on aga in
later.
Audi active lane assist: system fault!
Drive to an authorized Aud i dea ler or authorized
Audi Service Facility immediately to have the
malfunct ion corrected.
Audi active lane assist: Please take over steering
This message appears if you are not steering by
yourse lf. If th is is the case, active lane assist does
not switch off, but it is "not ready" to provide a
warn ing. The system can he lp you keep the vehi-
cle in the lane. However, you are responsib le for
driving the vehicle and must steer it yourself.
90
· Adjusting the vibration warning
Applies to: vehicles with Audi active lane assist
.,. Select: the
I
CARI
function button
>
(Car)
*
Sys-
tems
control button
>
Driver assistance > Audi
active lane assist.
You can switch the addit ional vibrating warning
in the steer ing whee l on or off.
(D
Tips
Your settings are automatically
stored and as-
signed to the re mote control key being used.

Advertisement

Table of Contents
loading

Table of Contents