Table of Contents
Advertisement
Dr iv ing
This message appears and a warning tone sounds
if you open the driver's door when the ignition is
switched on.
Press brake pedal to start engine
This message appears if you do not press the
brake pedal whe n st arting the engine.
fll
I s key in the veh icle?
This indicator light turns on and th is message ap-
pears if the ignition key was removed from the
vehicle when the engine was running . If the igni-
tion key is no longer in the veh icle, you cannot
switch on the ignit ion or start t he engine once
you stop it. You also cannot lock the vehicle from
the outside.
Shift to P, otherwise vehicle can roll away.
Doors do not lock if lever is not in P.
This message appears for safety reasons if the
transmission is not in the P position when you
switch the ignition off . Move the selector lever to
the P position. Otherwise the veh icle is not pro-
tected from rolling and it cannot be locked .
II
Key is not recognized. Hold back of key
against marked area. See owner's manual
If the indicator light t urns on and th is message
appears, there is a malfunction
c:;,
page
74.
Starting the engine when there is a
malfunction
It may not be possible to start the engine under
certain circumstances, for example if the battery
in the vehicle key is drained, if interference is af-
fected the key or if there is a system malfunc-
tion.
Fig. 83
Center conso le/ ma ster key: sta rt ing t he engine if
t he re is a ma lfun ct ion
74
Requirement : the message Key is not recog-
nized. Hold back of key against marked area.
See owner's manual must displayed and the
II
indicator light must tu rn on .
.,. Hold the mast er key in the locat ion ind icated as
shown in the illustration
f>l ) c:;,
fig. 83.
.,. Press the brake pedal
c:;,
&.
in Starting the en-
gine on page 73 .
.,. Press the
~ I S _ T_ A _R _T _ E_ N _ G _ I _ N _ E _S _T _O _ P ~ I
button. The
engine will start .
.,. Drive to an author ized Audi dealer or author-
ized Audi Service Facility immediately to have
t he malfu nction corrected.
@
Tips
You can view the message again by pressing
the
! ST A RT ENGI N E ST OP I
butt on.
Electromechanical
parking
brake
Operation
The electromechanical parking broke replaces
the hand broke.
Fig. 84
Cente r conso le: Parking bra ke
.,. Pull on t he swi tch @)
c:;,
fig. 84
t o apply t he
parking brake. The indicator l ights in the switc h
and -
(USA models)/ .
(Canada mode ls) in
the inst rument cluste r ill uminate .
.,. With the ignition switched on, step on the
brake pedal or the accelerator pedal and press
the switch ®lat the same time to release the
park ing brake. The indicator lights in the switc h
and -
(USA models)/ .
(Canada mode ls) in
t he inst rument cluste r go out .
Advertisement
Table of Contents
