Audi RS 7 Sportback 2016 Owner's Manual page 71

system runs continuously at maximum cooling or
heating power. There is no temperature regula-
tion.
Adjusting the blower ~
You can adjust the volume of air generated by the
blower to your preference. To have the blower
regulated automatica lly, press the
IAUTOI
but-
ton.
~
Adjusting air distribution
You can manually select the vents where the air
will flow. To have the air dist ribution reg ula ted
automatically , press the
IAUTO !
button.
~
Adjusting seat heating*/seat ventilation*
Pressing the button switches the seat heating/
seat ventilat ion on at the highest setting (leve l
3). The LEDs indicate the temperature level. To
reduce the temperature, press the button again .
To switch the seat heating/seat ventilation off,
press the button repeated ly until the LED turns
off .
After 10 minutes, the seat heating automatically
switches from level 3 to level 2.
I@
FRONT
I
Switching the defroster on/off
The windshield and s ide windows are defrosted
or cleared of condensation as qu ickly as possib le.
The maximum amount of air flows mainly from
the vents below the windshield. Recirculation
mode switches off. The temperature shou ld be
set to approximate ly 22 °C.
The
IAU TO I
button switches the defroster off.
IQiD REARI
Switching the rear window defogger
on/off
The rear window heate r o nly operates when the
engine is running. It sw itches off automatical ly
after a few minutes, depending on the outs ide
temperature.
To prevent the rear w indow heater from switch-
ing off automatically , press and hold the
IQiil
REAR
I
button fo r more t han 2 seconds. This is stored
until the ignition is switched off.
Warm and cold
I
SYNC !
Synchronization
When synchronization is switched on, the set-
tings for the driver's s ide are applied to the front
passenger's side (except for seat heating/ventila-
tion *). The settings in the rear are also synchron -
ized. Synchronization switches off if the settings
are adjusted on the front passenger's side or in
the rear.
You can synchronize the settings in a row by
pressing and holding a control. For example, to
apply the settings for the front passenger's side
to the driver's side, press and hold the control on
the front passenger's s ide. The same applies to
the rear.
Residual heat*
With the ign ition turned off, you can activate the
residual heat function by pressing the~ button
<=>
fig. 77. The residual heat from the coolant is
used to heat the veh icle inter ior. The residual
heat function sw itches off automat ically after
about 30 minutes.
Air vents
You can open or close the center and rea r vents in
the cockpit and the vents in the rear center con-
sole and door pillars using the ridged thumb-
whee ls. The levers adjust the direction of the air-
flow from the vents.
_&.
WARNING
- You should not use the recirculation mode
for an extended period since no fresh air is
drawn in. With the air-conditioning switch-
ed off, the windows can fog up , which in-
creases the risk of an accident.
- Individuals with reduced sensitivity to pain
or temperature could develop burns when
using the seat heat ing funct ion. To reduce
the risk of injury, these individuals should
not use seat heating .
(D
Note
To avoid damage to the heating elements in
the seats, do not kneel on the seats or place
heavy pressure on one point of the seat.
69