Table of Contents
Advertisement
Emergency
assistance
- Passengers must not remain in the vehicle
when it is jacked up.
- Make sure that passengers wait in a safe
place away from the vehicle and well away
from the road and traffic.
- Make sure jack pos it ion is correct, adjust
as necessary and then continue to raise
the jack.
- Changes in temperature
or load can affect
the height of the vehicle.
(D
Note
Do not lift the vehicle by the sill. Position the
vehicle jack only at the designated lifting
points on the sill. Otherwise, your vehicle will
be damaged.
@
Tips
The vehicle jack mode* switches off automati-
cally at speeds above 6 mph (10 km/h).
Removing and installing the sill extension
cover
Applies to: vehicles with sill extension
Fig. 205
Sill: removing the cover
.,. Pull the cover down to remove it.
c:>
fig. 205
.,. To install the cover, insert it in the mount and
press it upward until it clicks into place. The
cover must be flush with the surface of the sill
extension .
1 >
App lies to vehicles with ceramic brake rotor s*: Use a sec-
on d alig nment pin* (sto red in the s pare whee l well mold -
ing) fo r the lower hole, fo llowing t he de scription for the
firs t a lignment pin.
246
@
Tips
Some models may also have a cover for the
rear vehicle lift point.
Taking the wheel off/installing a wheel
Follow these instructions step -by-step for chang-
ing the wheel.
Fig. 206
Changing a wheel : using the sc rewdr iver handle
(with the blade removed) to turn th e bol ts
Fig. 207
Changing a whee l: alignment pin inside the top
hole
After you have loosened all wheel bolts and
raised the vehicle off the ground, remove and re-
place the wheel as follows:
Removing the wheel
.,. Us e the
hexagonal socket in the screwdriver
handle
to completely remove the topmost
wheel bolt and set it aside on a clean surface
c::>
fig. 206.
.,. Screw the threaded end of the
alignment pin
from the tool kit hand-t ight into the empty bolt
hole
¢
fig. 201
1
> .
.,.
Advertisement
Table of Contents
