Advertisement
18. Hook the ,;Z" end of clutch cable wire into
-clutch grip. See figure 16.
19. Hold the clutch grip so that the grip is down
against the handle. Adjust the clutch control
cable so that the slack is taken out of the con¬
trol wire. Tighten the two hex nuts at the cable
support bracket. Control wire should now be
straight.
Do not overtighten control wire.
Too much tension may cause it to
break.
FIGURE 16.
20. To check the adjustment, disconnect the
spark plug wire from spark plug to prevent ac¬
cidental starting. Secure end of spark plug
wire in the "V" slot on the engine. See figure
-17. With the clutch grip released (neutral posi¬
tion), pull starter cord several times. The tines
should not turn. If they do, adjust the hex nuts
at the cable support bracket. Check again for
correct adjustment.
FIGURE 17.
21. Secure the throttle control cable and clutch
control cable to the handle and brace with
cable ties (H) provided. Cut off excess ends.
-* See figure 18.
22. Assemble the grips to the ends of the upper
handles. They will slip on more easily if they
are first soaked in warm, soapy water.
FIGURE 18.
9
Advertisement
