Advertisement
7. Remove the clevis pin and hairpin cotter from
— the inner tine assemblies as shown in figure 7.
Place the right and left hand tine assemblies
in position on tine shaft. Secure with clevis
pins and hairpin cotters.
NOTE
Be certain the tine assemblies are
assembled on the tine shaft so that
the sharp edge of the tines enter the
soil first. See figure 7.
FIGURE 7.
8. The left handle has a clutch grip already
assembled to it. Assemble the left and right
hand handles (Q and R) to the rear tiller frame
— as shown in figure 8. Secure with hex bolts
(D), lock washers (B) and hex nuts (C), finger
tight only (do not tighten).
FIGURE 8.
Lock Washer <B)
Hex Nut (C)
9. Attach the right and left hand braces (U) to the
tailpiece. The braces have two holes to pro¬
vide handle height adjustment. Select hole for
either high or low position. Secure to tailpiece
with hex bolts (D), iock washers (B) and hex
nuts (C), finger tight only (do not tighten). See
— figure 9.
FIGURE 9.
6
Advertisement
