Advertisement
Handle
Panel (S)
FIGURE 10.
10. Place the handle panel (S) in position on the
handles. Secure the upper holes in the panel
to the handles with carriage bolts (A), lock
washers (B) and hex nuts (C), finger tight only.
— See figure 10.
11. Place carriage bolt (A) through the handle
panel, handle and handle brace on the lower
right hand side of the handle panel, finger
tight only. See figure 10.
12. Place carriage bolt (A) through the handle
panel, handle, handle brace and cable support
bracket on the lower left hand side of handle
-panel as shown in figure 11. Use the bottom
hole in the cable support bracket. Secure with
lock washer and hex nut, finger tight only.
FIGURE 11.
13. Place flat washer (I) between handle and up¬
per hole on cable support bracket. Secure
-with self-tapping screw (J). See figure 12.
14. Now tighten securely the self-tapping screw
and all nuts and bolts on handles and braces.
FIGURE 12.
7
Advertisement
