Advertisement
FIGURE 13.
15. Assemble the throttle control to the handle
panel as follows.
-A. Hold
the
throttie
control
assembly
beneath the handle panel. Turn the control
sideways and insert the lever up through
the wide portion of the slot on the handle
panel. See figure 13A.
B. After the end of the lever is through the
slot, turn and then tip the control forward
as shown in figure 13B to slide it through
the slot.
NOTE
The lever must be all the way to the
back of
the control housing as
shown in figure 13B.
C. Push the control back into the slot in the
handle panel and press in place. Be certain
the control is locked securely into the slot.
See figure 13C.
16.-Hook the end of the clutch cable (already at¬
tached to the tiller) over the extension spring
-as shown in figure 14.
NOTE
If spring has come loose, it must be
reassembled to the weld pin on the
idler bracket.
17. Remove one nut and lock washer from other
end of clutch cable. Slip the wire up through
slot on cable support bracket. Start hex nut
and lock washer back on end of clutch cable.
-See figure 15. Do not tighten at this time.
FIGURE 15.
8
Advertisement
