White ROTO BOSS 510 Instruction Manual page 5

Tailpiece
FIGURE 4.
4. Secure the tailpiece to the rear frame rails
with two hex bolts (D), lock washers (B) and
— hex nuts (C). See figure 4. Tighten all four hex
bolts and nuts securely. Two
Vz"
wrenches
are required.
5. Assemble wheels (T) to wheel yoke (W) with
shoulder bolts (L), belleville washers {M}
(cupped side of washer is against the wheel
yoke), lock washers (N) and hex nuts (O) as
— shown in figure 5. A wrench and an ad¬
justable wrench is required.
FIGURE 5.
6, Place the end of the wheel yoke up through
the rectangular hole in the tailpiece. Secure
with clevis pin (K) and hairpin cotter (F). See
— figure 6.
FIGURE 6.
5