Sharp SWB3085HS Operation Manual page 28

Smart convection wall oven with microwave drawer oven
Hide thumbs Also See for SWB3085HS:
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING
ERROR DISPLAY AND CONDITIONS
LOWER MICROWAVE
ERROR NO.
ERROR
EC-001
Sensor error
EC-002
Communication
error
UPPER OVEN
ERROR NO.
ERROR
EC-003
Oven TH short
(Required to
check the log
data on the
cloud.)
EC-004
Oven TH open
EC-005
Meat Probe short
EC-006
Meat Probe open
EC-007
Door lock error
(during locking and
unlocking)
EC-008
Power Board
Failure
EC-009
Communication
error
EC-010
ACK hardware
error (Drawer)
EC-011
ACK hardware
error (Oven)
SHARP ELECTRONICS CORPORATION
100 Paragon Drive • Montvale, New Jersey 07645 • 1-800-BE-SHARP (237-4277)
SHARP ELECTRONICS OF CANADA LTD.
335 Britannia Road East Mississauga • Ontario L4Z 1W9 • 877-278-6709
E
DISPLAY/CIRCLE
SOUND
Red + No Blink
BUZZER
(beep ×10)
Red + No Blink
CIRCLE
SOUND
Red + No Blink
BUZZER
(beep ×10)
Red + No Blink
Red + No Blink
Red + No Blink
Red + No Blink
Red + No Blink
Red + No Blink
BUZZER
(beep ×10)
Red + No Blink
28
CONDITIONS
Occurs when Sensor cooking is interrupted.
Hardware error (DISP<=>Drawer).
Errors can be displayed during heating and when the OPEN/
CLOSE key is pushed.
CONDITIONS
When the temperature inside the OVEN is too high, the
heater turns off.
This error can also occur when the thermistor has failed and
misidentification that the temperature is high when it is not.
The heater stays OFF all the time, so the food is not heated.
The oven may mistakenly judge that the temperature is low
and the heater turns on all the time.
Occurs when the temperature of the meat probe becomes
too hot. (Possible reason: The probe was Preheated
without inserting into food/The Probe broken/etc.)
You can see that the meat probe is broken or not inserted
well into the food.
Occurs when the meat probe is not set in the oven or if the
meat probe detaches from the OVEN during heating.
Occurs when self-clean is started and the door is unable to
lock. The oven keeps waiting until the door is locked. (The
heating will not start until it is locked.)
The oven is out of order. (Power board failure)
Hardware error (OVEN)
Errors can be displayed during heating.
Hardware error (ACK of Drawer). Error judgment is
performed when Wi-Fi is turned on, if there is a hardware
error, this error message is shown.
Hardware error (ACK of Oven). Error judgment is per-
formed when Wi-Fi is turned on, if there is a hardware
error, this error message is shown.

Advertisement

Table of Contents
loading

Table of Contents