Advertisement
MEMPHIS
A
D10
!>
NCE
19
VIV
SIXFIVE SERIES
Wiring Multi-Channel Amps
Speaker have a positive and negative marking on the
terminals.
These are used
to indicate
polarity
and
must be
considered when wiring speakers
or subwoofers to an
amplifier.
Amplifiers also have positive and negative markings on their speaker
outputs.
Use
these
marking
to
match
polarities to ensure the speakers are in
phase.
Failure to wire speakers or woofers in phase with one another
will result
in
a loss
of
bass.
All Six
Five Series amplifiers require a minimum 2 ohm impedance in stereo or q ohm
in
mono (bridged)
mode.
Always
check
your speaker
load with
a multi-meter before hooking
them
up
to the
amplifier.
The VIVII00.4¥2 amplifier is stable
to
2
ohms
stereo or 4 ohms bridged mono. The VM300.5V2 // VIVBELLE amplifiers are
stable to 2 ohms stereo
or q ohms bridged mono
(front &
rear
channels) and stable
to
2
ohms
[sub
channel).
Any Impedance
[load) smaller than
what
Is recommended will
damage the ampllflerl Such damage is not covered under
warranty,
so
pay
strict attention
to
what connections are made
to
the
amplifier.
VIVQOO.QV2 // VIV600.'IV2
VIV1300.5V2 // VIVBELLE
@
I
l\[
1-40
Speaker/Sub
qo
Speaker/Sub
•
•
qo
Speaker/Sub
2-LtO Speaker
2-LtO Speaker
Advertisement
