Table of Contents
Advertisement
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Slide in the middle panel (fig. B).
2.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
Hook the seal in to the bottom of the panel again (fig. D).
4.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
Problem
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut
Power cut
and three
0
zeros light up in
the display.
The oven does
There is dust on
not heat up.
the contacts.
The oven door
The oven door
cannot be
is locked by
opened. The
H
self-cleaning.
symbol lights
up in the dis-
play.
16
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the clock.
Turn the control knobs back
and forth several times.
Wait until the oven has
x
cooled down and the
symbol goes out.
Insert the uppermost panel at an angle to the back into the
5.
brackets. Take care not to push the seal to the back (fig. E).
Insert the two small seals on the left and right of the panel
6.
again (fig. F).
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.
Problem
The oven does
not heat up. The
colon in the dis-
play flashes.
F8 appears in
the display.
Error messages
If an error message with
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself if the following error
messages are displayed.
Error message Possible cause Remedy/information
"‹‚‚
H
"‚‚†
Possible cause Remedy/information
The oven is in
Switch off the circuit
demonstration
breaker in the fuse box and
mode.
switch it on again after
approximately 20 seconds.
Now, within approx.
2 minutes, press and hold
the
h
button for approx.
4 seconds until the colon
lights up continuously.
Automatic
Turn the function selector to
switch-off has
the off position.
been activated.
"
appears, press the
A button was
Press all buttons individu-
depressed for
ally. Check whether any but-
too long or is
tons are jammed, covered
covered up.
up or soiled.
The tempera-
The oven door locks and
ture in the cook-
heating is suspended. Wait
ing
until the oven has cooled
compartment is
down. Press the
too high.
and reset the clock.
0
button. Then
0
button
Advertisement
Table of Contents
