Ebyte E95M-DTU User Manual page 6

Chengdu Ebyte Electronic Technology Co.,Ltd.
Using USB to RS 235 or other means;
3
Start two serial port debugging assistant, select serial port port rate of 9600bps (default), check mode of 8N1,
4
can achieve serial port transmission;
If the customer needs to switch the working mode, it can switch the different working modes (M0 indicator
5
light, M1 indicator light) through the Mode button control. Press the Mode button once for about 1ms to
switch the mode once. Details of the mode switching are shown in the following table:
No. Class
Through
pattern 0 transmission
mode
pattern 1 WOR pattern
Configuration
pattern 2
mode
Copyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd.
M1 M0
Serial port open, wireless open, transparent transmission
light light
(factory default mode), support special command air
goes out goes out
configuration.
light Can be defined as WOR sender and WOR receiver, support
light on
goes out aerial wake up
light The user accthe register through the serial port to control the
light on
goes out working status of the station. The user can configure the station
E95M-DTU(400SLxx-xxx) User Manual
Note
6