Advertisement
Move the assembled rear cover close to the panel
unit, then connect the joystick cable to the
connector of interface board. Put down the rear
S23
cover and push the rear cover on the positions
marked as the picture below shown for
mechanisms engagement.
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the rear cover with the unit. Paste
S24
2pcs label on the specific positions.
(No.1~4 screw size=M4x11; Torque=11
2
4
Insert a DP out Cap into the DP out connector. Take
a stand base close to the monitor. Fit the two tabs
S25
on the upper part of the stand into the grooves, and
then lower the stand so that the monitor mounting
area snaps onto the stand.
5. Disassembly and Assembly Procedures
1kgfxcm)
±
3
1
Lift up the monitor to check the gap between the
front bezel and the panel, then provide power supply
S26
and a video signal to the
monitor for functionality check.
monitor, then turn on the
Advertisement
