Advertisement
5.2 Assembly Procedures:
Place a bracket chassis base on a protective
S1
cushion, then stick 7pcs Silicon sheets on the
positions as the picture below shown.
Turn over a power board and put the power board
S2
into the bracket chassis, settle the panel power
cable to the correct position.
Take a interface board, connect 1pcs LVDS cable to
the connector of the interface board, then connect
the cable of the power board to the connector of the
interface board. Turn over the interface board and
locate it into the main chassis. Use a Philips-head
S3
screwdriver to tighten 7pcs screws for locking the
interface board and power board. Turn over the
chassis and connect 1pcs cable to the connector.
(No.1 screw size=M4x8, Torque=7.5
No.2~7 screw size=M4x8, Torque=7.5
7
5. Disassembly and Assembly Procedures
kgfxcm;
±0.5
kgfxcm)
±0.5
4
5
2
6
1
3
Turn over the bracket chassis, and then take 1pcs
S4
black mylar to insert the hooks of the bracket
chassis to cover the power board.
Panel preparation: Take out 1pcs panel module from
the carton, remove the protective film by tearing off
S5
the tapes, then Examine the panel surface
according to inspection criteria. Turn over the panel
to place screen faced down for later assembling.
Take1pcs touch board,1pcs key cable and 1pcs front
bezel, then connect the key cable to the connector
of the board. Tear off the release paper and paste
the touch board on the correct position of the front
S6
bezel, then paste 1pcs mylar to cover the touch
board. Move the front bezel close to the panel
module, then assemble the front bezel with the panel
module.
Advertisement
