Toro Z Master 7500-D Series Setup Instructions page 3

5
Raising the Rollover
Protection System (ROPS)
No Parts Required
Procedure
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
1. Pull the knob and rotate 90° to the unlatched
position (Figure 1).
2. Raise the roll bar to the operate position, and
rotate the knobs so that they move partially into
the grooves (Figure
3. Raise the roll bar to the full upright position while
pushing on the upper roll bar and the pins snap
into position when the holes align with the pins
(Figure 1).
1. Upper part of the roll bar
2. Knob in the latched
position
3. Pull the knob to unlatch.
1).
Figure 1
4. Rotate the knob out 90°
to hold it in the unlatched
position.
5. Knob in the unlatched
position
4. Push on the roll bar and ensure that both pins
are engaged
1. Engaged position
g243267
3
(Figure 2).
Figure 2
2. Partially engaged—do
not operate the machine
with the roll back in this
position.
g008619