Toro Z Master 7500-D Series Setup Instructions page 6

8
Checking the Drive Wheel
Gearbox Oil
No Parts Required
Procedure
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the rear of machine and support it using
jack stands (or equivalent support) just high
enough to allow the drive wheels to turn freely.
4. Remove the wheel and orient the gearbox with
the drain port on the bottom and fill port on top
(Figure 6).
5. Place a drain pan under each check port
6).
Remove and retain the check plug.
6. Ensure that the oil level is up to check port and
is correct consistency.
7. Install the check plug when complete.
1. Wheel gear box
2. Check plug
8. Repeat on the opposite side.
4
3
Figure 6
3. Drain plug
4. Fill plug
Important:
the gearbox may damage it.
(Figure
1
2
g364528
6
Do not overfill the gearbox; overfilling