Master Image MI-2100R Installation & Operation Manual page 77

This file should contain the information below:
<?xml version="1.0" encoding="utf-8"?>
<StreamDevice name="MasterImage" xmlns="http://schemas.qubecinema.com/Automation/StreamDevice/2008-
01-26">
<Method name="Start">
<Instructions>
<Send>Start&#x0D;&#x0A;</Send>
</Instructions>
</Method>
<Method name="Stop">
<Instructions>
<Send>Stop&#x0D;&#x0A;</Send>
</Instructions>
</Method>
<Method name="3Dposition">
<Instructions>
<Send>PFD
</Instructions>
</Method>
<Method name="2Dposition">
<Instructions>
<Send>PFD
</Instructions>
</Method>
<Method name="PFDStop">
<Instructions>
<Send>PFD
</Instructions>
</Method>
</StreamDevice>
The symbols &#x0D;&#x0A
the xml structure.
Finally the automationcues.xml file can be edited so that the MI-2100R device is associated with
the command names that have been created; this allows the cues to be seen in the Qube
graphical interface.
Note: again this file is a shared file with other devices in the system so must be edited and not
replaced.
UP&#x0D;&#x0A;</Send>
Down&#x0D;&#x0A;</Send>
Stop&#x0D;&#x0A;</Send>
are necessary at the end of each command so close the command in
77
MI-2100R Installation & Operations Manual