Aiwa LX-110 Operating Instructions Manual page 2

Compact disc stereo system
Table of Contents

Advertisement

ENGLISH
WARNING
TO REDUCE
THE RISK OF FIRE OR ELECTRIC
SHOCK,
DO NOT EXPOSE
THIS APPLIANCE TO
RAIN OR MOISTURE.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
This compact disc player is classified as
a CLASS
1 LASER
product.
The CLASS 1 LASER PRODUCT label is located on the exterior.
CLASS 1
LASER PRODUCT
KLASSE 1 LASER PRODUKT
'LUOKAN 1 LASER LAITE
KLASS 1
LASER APPARAT
CAUTION!
Invisible laser radiation when open and inter
locks defeated. Avoid exposure to beam.
ADVARSEL!
i
Usynlig laserstaling ved abning, nar sikkerhedsafbrydereer ude
af funktion. Undga udseettelse for straling.
VAROITUS!
Laitteen kayttaminen muulla kuin tassa kaytt6ohjeessaa mainitulla
tavalla saattaa altistaa kayttajan turvallisuusluokan 1 ylittavalle
nakymattémalle lasersateiylle.
VARNING!
Om apparaten anvands pa annat satt an i denna bruksanvisning
specificerats, kan anvandaren utsatta for osnylig laser-stralning,
som éverskrider gransen fér laserklass 1.
OBSERVERA
Sa lange som apparaten ar ansluten till natet flyter en svag str6m
genom densamma, aven da den ar avstangd. Om man under en
langre tid ej har for avsikt att anvanda den, drag da ur natkabein.
BEMARK
Apparatet er stadig forbundet med lysnettet, sa laenge stikket er
tilsluttet til stikkontakten, selv om afbryteren er slaet fra. Hvis
apparatet ikke bruges i laengere tid, skal netledningen traekkes
ud.
1 ENGLISH
PREPARATIONS
PRECAUTIONS
Read the Operating Instructions carefully and completely before
operating the unit. Be sure to keep the Operating Instructions
for future reference. All warnings and cautions in the Operating
Instructions and on the unit should be strictly followed, as well
as the safety suggestions below.
Installation
1 Water and moisture — Do not use this unit near water, such
as near a bathtub, washbowl, swimming pool, or the like.
2 Heat — Do not use this unit near sources of heat, including
.
heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C
(41°F) or greater than 35°C (95°F).
Mounting surface — Place the unit on a flat, even surface.
Ventilation — The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and thie top of the
unit, and 5 cm (2 in.) from the each side.
- Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack
where ventilation may be impeded.
Objects and liquid entry — Take care that objects or liquids
do not get inside the unit through the ventilation openings.
Carts and stands — When placed or mounted on a stand or
cart, the unit should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause
the unit or cart to overturn or fall.
Condensation — Moisture may form on the CD pickup lens
when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
- The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function
normally. Should this occur, leave the unit for a few hours,
then try to operate again.
Wall or ceiling mounting — The unit should not be mounted
on a wall or ceiling, unless specified in the Operating
Instructions.
hw
a
o
~"
bo]
Electric Power
1 Power sources — Connect this unit only to power sources specified
in the Operating Instructions, and as marked on the unit.
2 AC power cord
- When disconnecting the AC power cord, pullit out by the
AC power plug. Do not pull the cord itself.
- Never handle the AC power plug with wet hands, as this
could result in fire or shock.
- Power cords should be firmly secured to avoid being severely
bent, pinched, or walked upon. Pay particular attention to
the cord from the unit to the power socket.
- Avoid overloading AC power plugs and extension cords
beyond their capacity, as this could result in fire or shock.
3 When not in use — Unplug the AC power cord from the AC
power plug if the unit will not be used for several months or
more. When the cord is plugged in, a small amount of current
continues to flow to the unit, even when the power is turned off.
Maintenance
Clean
the unit only as recommended
in the Operating
Instructions.
Damage Requiring Service
Have the units serviced by a qualified service technician if:
- The AC power cord or plug has been damaged
- Foreign objects or liquid have gotten inside the umit
- The unit has been exposed to rain or water
- The unit does not seem to operate normally
- The unit exhibits a marked change in performance
- The unit has been dropped, or the cabinet has been damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOUSSELF.
;

Advertisement

Table of Contents
loading

Table of Contents