Reception By Preset Number - Aiwa LX-110 Operating Instructions Manual

MANUAL PRESETTING
1 Press the TUNER BAND button repeatedly to
select a band.
aaa |
2 Press the ké4 DOWN or PPI UP button to select
a station.
Each time the button is pressed, the frequency changes.
@ When tuning in to.an FM RDS station
After "TUNE" on the display goes out, the Program Service
station name (*PS) is displayed and RDS lights up.
Program Service
station name (PS)
© When tuning in to the other stations
After "TUNE" on the disp!ay goes out, the station is
displayed.
* During FM stereo reception, STEREO lights up.
3 Press the SET button to store the station.
The selected preset number flashes.
4 Repeat steps 1 to 3 to store the stations.
The next station will not be stored if a total of 32 preset stations
have already been stored for all bands.
To search for a station quickly with the k¢¢ DOWN or
PI UP button (Auto Search)
Keep one of the buttons pressed until the tuner starts searching
for a station. The search stops when the tuner tunes in to a
station.
To stop the Auto Search manually, press one of the buttons.
* The Auto Search may not stop at stations with very weak
signals.
9 ENGLIsH
RECEPTION BY PRESET NUMBER
MODE/OSC
Press the TUNER BAND button to select a band.
Press the IJ PRESET button repeatedly.
Each time the button is pressed, the next higher number is
selected.
To select a preset number directly
Press the numbered buttons on the remote control.
Example:
To select preset number 15, press the +10 and5 buttons.
NR"
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the SET button, and within 4 seconds, press the BI CLEAR
button.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
To scan preset stations
Press the P-SCAN button on the remote control until "P.SCAN"
is displayed. The preset stations are received in order for 5
seconds each. The preset number flashes during eception.
To stop scanning, press the VOLUME + or — button.
To tune in to a station which is not preset
Press the TUNER BAND button to select a band, and press the
<< DOWN or PI UP button to select the station.
To play a tuned station when the power is off (Direct Play
Function)
Press the TUNER BAND button. The power is turned on and the
tuned station is played.
When an FM stereo broadcast contains noise
Press the TUNER MODE/OSC button on the rermte control to
display "MONO".
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so frat "MONO"
goes out from the display.
To change the MW tuning interval
The default setting of the MW tuning interval is ¢ kHz/step. If
you use the unit in an area where the frequency allovation system'
is 10 kHz/step, change the tuning interval as follovs.
Press the POWER button while pressing the BANDbaitton during
power is on.
To reset the interval, repeat this procedure.
* When the MW tuning interval is changed, all preset stations
are cleared. The preset stations have to be set.
¢ RDS functions may not work correctly if RDS transmission data
from the station contains too much interference orie reception
signal is too weak.