Table of Contents
Advertisement
On the road
Speed warn ing 1
lGJ /laJ
<Canada models)
You can use speed warning 1 to set the maximum
speed while you are driving. This setting will re -
main in effect until you turn off the ignition, as-
suming that you have not changed or reset the
setting .
The speed warning symbo l
lDJ/[f]
(Canada mod-
els) in the warning 1 display appears when you
exceed the maximum speed. It goes out when
the speed falls below the stored maximum
speed.
The speed warning symbo l will also go out if the
speed
exceeds
the stored maximum speed by
more than about 25 mph (40 km/h) for at least
10
seconds. The stored maximum speed is delet-
ed.
Sett ing speed warning 1
¢
page 70.
Speed warning 2
lCl/lDJ
<Canada models)
Storing warning 2 is recommended
if you
always
want to be reminded of a certain speed, for ex-
ample when you are trave ling in a country that
has a general maximum speed limit, or if you do
not want to exceed a specified speed for winter
tires.
The speed warning 2 symbol
lCI J (a1
(Canada
models) appears in the disp lay when you exceed
the stored speed limit. Unlike warning 1, it will
not go out until the vehicle speed drops be low
the stored speed limit.
Sett ing speed warning 2
¢ page 70.
@
Tips
Even though your vehicle is equipped with a
speed warning system, you should still watch
the speedometer
to make sure you are not
driving faster than the speed limit.
70
Speed warning
1:
setting a speed limit
Warning threshold 1 is set by the button .
Fig. 79 Sect ion of instrument cluster: Set/C heck button
Storing the maximum speed
.,. Drive at the desired maximum speed .
.,. Press the knob butto n
c::>
fig.
79 until the sym-
bol appears.
Resetting the maximum speed
.,. Drive the vehicle at a speed of at least 3 mph
(5 km/h)
.,. Press the knob for mo re than 2 seconds .
The speed warning symbol
[IH
(USA
models)/ (01
(Canada models) w ill appear br iefly in the display
when you release the button to indicate that the
max imum speed has been stored successfu lly.
The maximum speed rema ins stored until it is
changed by pressing the button again briefly or
until it is deleted by a lengthy push on the but-
ton.
Speed warning
2:
setting a speed limit
Switches in the wiper arm ore used to operate
warning threshold 2 .
~--
®
Fig. 80
Controls
Advertisement
Table of Contents
