Table of Contents
Advertisement
Openin
g and c losing
Programming the Homelink transmitter
Fig. 33
Overhead console: Homelink keypad
Fig. 34
Front bumper: loca t ion of transmitter unit
The transmitter is programmed in two phases.
For rolling code transmitters,
a third phase is al -
so necessa ry.
Phase
1:
programming the overhead keypad
l.
Make sure you r vehicle is with in operat ing
range of the remote controlled garage door
ope ner.
2 . Set the park ing brake ~
&
in Description on
page 35 .
3. Turn the ignition o n. Do not sta rt the e ngine!
4.
Press and hold t he two outside Home Link
buttons
(D
and ®
for approx imat ely 20 sec-
onds until indicator light @ ~ fig. 33 begins
to flas h. The n release both buttons. Do not
hold the buttons for longer than 30 seconds.
.,. This procedure only needs to be perfo rmed
once.
It
erases the factory-set default codes
and does not have to be repeated to prog ram
additional remote controls .
5 . Press and hold the Homelink button
(D,
®
or ®
until the ind icator light @ st arts
flash ing slowly. Release the butt on.
36
.,. The system will remain in programming mode
for
5
minutes .
Go
to the front of the vehicle
and proceed with phase 2 .
Phase 2:
programming the bumper mounted tran smit
ter
6. Hold the original remote control at a dis-
tance between 0- 6 in. (0- 15 cm) from the
bumper below the appropr iate headlight for
you r vehicle ~ fig. 34 (use the shortest dis-
tance possib le).
7. Aim t he remote control ju st below t he driver
side headlight.
8 . Press and ho ld t he activation but to n on the
remote co ntrol.
.,. May be different in Canada . If so, press and re-
press (cycle) the activation button on your re-
mote control every two seconds.
9 . The emergency flashers will flash three
times (after about
15-60 seconds) when the
programmi ng is successf ul. Release the but-
ton on t he remote contr ol.
.,. To program more devices, repeat st eps
4
to
9.
10 . Press a nd ho ld t he tr a ined Home lin k button
and observe t he ind icator light @ ~ fig. 33.
.,. If the ind icator light is solid/co nti nuous, pro-
gramm ing is complete and your device sho uld
activate when you press and release the trained
Homelink button .
.,. If the ind icator light blinks rapidly for 2 sec-
onds and is the n a so lid/continuous light, pro-
ceed with phase 3 to program a roll ing code de-
vice.
Phase
3:
rolling code programming
.,. A second person o n a ladder wh o ca n safe ly
reach the garage door opener motor is recom-
mended .
11. Locate the "learn" but t on on the ga rag e doo r
o pener mot or (refer t o the oper ati ng instr uc-
t ions for t he op ener, as the locat io n of th is
button may vary by manufacturer) .
12 . Pres s and release the learn button on the ga -
rage door opener motor.
.,. Note: once the button is pressed, there are 30
seconds in which to initiate t he next step.
13 . On t he Home link keypad ins ide the ve hicle,
firmly press and hold the Homelink butto n
IJ,,
Advertisement
Table of Contents
