Removing The Mower - Toro 74765 Operator's Manual

1
Figure 56
Mower Decks with 1 Blade
1. Blade front to rear
2. Measure from the tip of the blade to the flat surface here.
2
1
Figure 57
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here.
5. Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 56).
Note: If the front blade tip is not 1.6 to 7.9 mm (1/16
to 5/16 inch) lower than the rear blade tip, adjust the
front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower
2
G014631
2
G009658
2
(Figure 58).
1
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
8. To lower the front of the mower, loosen the adjustment
nut.
9. After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (Figure
10. When the front-to-rear blade slope is correct check the
side-to-side level of the mower again; refer to
from Side to Side (page

Removing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key from the
ignition switch, and wait for all moving parts to stop
before leaving the operating position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod,
and remove the rod from the deck bracket
Note: Carefully lower the front of the mower deck
to the ground.
40
3
2
G014634
Figure 58
3. Locknut
56).
38).
Leveling
ARK
(Figure 59).