Download Print this page

Specifications; Protective Circuit - Monacor STA-200D Instruction Manual

Digital stereo pa amplifier
Hide thumbs Also See for STA-200D:

Advertisement

3) Set the desired volume with the controls LEFT
and RIGHT. In case of overload of the ampli-
fier, the red LED CLIP (5) will light up. Turn
back the control accordingly.
CAUTION
Never adjust the amplifier
&
to a very high volume. Per-
manent high volumes may
damage your hearing! Your
ear will get accustomed to high volumes
which do not seem to be that high after
some time. Therefore, do not further in-
crease a high volume after getting used to it.
4) If a unit has been connected to the 3.5 mm
jack PLAYER (1), use the control GAIN (2) to
set the input sensitivity. Thus, differences in
volume will be balanced when switching over
to a unit connected to the jacks INPUT 1-4
(10) When a unit with low output level is
connected, the control can also be used to
increase the input sensitivity in order to obtain
the maximum output power.
7 Protective Circuit
To prevent damage to the amplifier, a protective
circuit has been integrated. When the protective
circuit has been activated, the amplifier will be
muted and the LED PROTECT (5) will light up:
1. in case of a short circuit at a speaker output
2. in case of overheating of the amplifier
(The LED OVERHEAT will also light up.)
When the LED PROTECT lights up, always switch
off the amplifier and eliminate the fault.
Another protective circuit will switch off the
amplifier when there is overvoltage in the mains
voltage. When the mains voltage has returned to
its standard value, the amplifier will be switched
on again.
8 Specifications
RMS output power
Stereo 4Q:
2 x 125W
Stereo 82:........... 2x
75W
Maximum output power: .. 300W
Inputs
INPUT 1 -4:
1 V/23k2, RCA
PLAYER:
90 mV-1 V/46 k2,
3.5 mm jack
Frequency range:........20- 20 000 Hz
S/N ratio:
> 100dB (A-weighted)
Crosstalk attenuation:....> 56 dB
THD:
<
0.05 %
Power supply...........230\V/50 Hz
Power consumption:..... 350VA max.
Ambient temperature:....0-40°C
Dimensions (W x H x D): . 482 x 44 x 268 mm,
1 RS (rack space)
Weight:...............5 kg
Subject to technical modification.
10
All rights reserved by MONACOR" INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
reproduced in any form or by any means for any commercial use.

Advertisement

loading

This manual is also suitable for:

25.5070