Advertisement
FRONT PANEL FACILITIES
F-X65Z/F-X55ZL
DIGITAL SYNTHESIZER TUNER:
TX-588Z/TX-SS5ZL
STEREO TUNER
|
TX-3332/TX-333Z4,
The illustration shows model F-X58ZL.
ceo
@@o90
8
.é)
NOTE:
The illustration is of the model for use in continental European and the U.K.
@
FREQUENCY
display
Permits reading the received frequency at a glance from the displayed figure.
The FM band is indicated by MHz, and the AM (MW or LW) band by kHz.
@
STEREO indicator
@ FUNCTION switch
MW: Push to receive MW band broadcasts.
LW: Push to receive LW band broadcasts.
FM; Push to receive FM band broadcasts.
[Only AM/FM switching is available for models F-X55Z and TX-555z.
=)
@
MEMORY switch
Push to operate the memory circuit. After the switch is pressed, the memory
circuit will function for about ten seconds. During this time, press one of the
STATION CALL switches to memorize the station being currently received. if
more than ten seconds elapse after the MEMORY switch is pressed, no sta-
tions can be memorized, In this case, press the MEMORY
switch again if you
wish to memorize a station.
@ STATION CALL switches
These are used to preset and recall broadcasting stations. A total of 16 sta-
tions can be preset [FM: 8, AM (MW or LW): 8).
¢
To tune in to a prememorized station, push the appropriate STATION
CALL switch.
*
Once the stations have been preset, all you have to do to recail them is
push the STATION CALL switch.
@
TUNING
switches
These are used to locate the stations. Push either of these two switches; the
left switch "—' to go to a lower, and the right switch "+" to go to a higher
frequency.
@
TUNED
indicator
This lights to indicate when the finest tuning of a station has been achieved.
The illustration shows model F-X33ZL.
NOTE:
The illustration is of the model for use in continental Europe and the U.K.
@ POWER indicator
@
TUNED
indicator
This lights up to indicate when finest tuning of a station has been achieved.
@
STEREO indicator
This lights when a stereo program has been picked up during an FM broad-
cast.
@
Dial pointer
@ Function switch
MW: Push to receive MW band broadcasts.
LW: Push to receive LW band broadcasts.
FM: Push to receive FM band broadcasts.
{ Only AM/FM switching is available for models F302 and TX. 3332,
@ Tuning knob
Rotate this knob to pick up stations.
7
<ARB1001>
Advertisement
