Advertisement
RELAY PLAYBACK
lustration shows model DC-X55Z.
Playback can be started from either Deck | or Deck il.
5.6
Extended Relay Playback
Extended relay playback lasting 8 hours is possible when C-60 tapes are used,
and playback lasting 12 hours is possible when. C-90 tapes are used and the
reverse mode switch for both decks is set to the (C_>) position.
Press the POWER switch to turn power on.
Load pre-recorded tapes in both decks.
Set the reverse mode switch for Deck | and Deck II.
NS
Relay playback will be performed according to the setting of the mode swit-
ches as shown here.
Playback Method
Deck |
Deck
|
fy
Extended relay playback
| One roundtrip on each deck
|
=):
Continuous playback
on Deck |
Continuous playback on Deck if
me)
4, Search for the start of the first desired program on the tapes in deck | and
deck Ul.
5. Press the PLAY ( €*} } switch on the deck to be started first
* Playback starts.
6
Press the PLAY { €+} } switch on the other deck.
* This deck is now set to the relay playback stand-by mode and will start
playback when the deck started first stops or is set to the pause mode.
7. Relay playback will zake place according to the method selected in step 3,
after which both decks will stop automatically.
Extended Relay Playback | Stops after 4 roundtrips on each deck
|
One roundtrip on each deck | Sto}
atter 1 roundtrip on each deck
|
Continuous playback
1 roundirip on Deck Ht followed by 8 round-
on Deck |
trips on Deck I
|
round |
Continuous playback
7 roundtap on Deck | followed by
on Deck fl
trigs on Dack
8. To stop relay playback, press the STOP/EJECT ( 8/&
} switch on both
decks.
MIC MIXING FOR SINGING ALONG WITH RECORDED
ACCOMPANIMENT
The illustration shows model DC-X55Z,
MIXING
KNOW-HOW
Mixing involves combining the signals from two input sources {a microphone
and a tape, for exampie}.
SINGING
ALONG
WITH A TAPE
1. Plug a microphone into the MIC jack.
2.
Press the POWER
switch to turn power on.
3.
Adjust the volume to a suitable level.
4.
Set the MIC MIXING control to the center position.
* If howling occurs
(a high-pitched sound
from the speakers},
take the
following steps.
414
<ARB1001>
{1} Move the mic away from the speakers.
{2) Lower the volume.
#%e
5.
Select the desired program source using the FUNCTION
switches,
6.
Start playback of the program source.
7.
Adjust the overall volume.
8.
Using the MIC MIXING control, adjust the sound balance.between the mic
and the program source
a
9.
Start recording on cassette tape deck amplifier
10. Sing along with the program using the microphone.
Because both MIC and SOURCE
inputs are controlled together by the mix-
ing function, the mixing control can also be used as a manual fader when
recording.
+ Fading refers to the recording technique in which the volume of an input
source is gradually increased or decreased.
MIXING
RECORDING
You can use the mixing feature to record input from a microphone and another
source together.
1. Perform steps 1 to 8 in the section "SINGING ALONG WITH A TAPE."
2. Load a tape for recording into record/play deck
3. Press the REC { @ } switch on record/play deck.
4. Sing along with the program source
Advertisement
