Advertisement
TROUBLESHOOTING
incorrect operations are often mistaken far trouble and malfunctions. if you think that there is something wrong with this component,
check the points below.
Sometirnes
the trouble may
le in another component.
Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exe
work,
Cassette Deck/Amp
ising the checks fisted below, ask your nearest PIONEER authorized service center or your dealer to carry out repair
Symptom
Cause
Remedy
No sound from speakers.
© ts volume level turned down?
* Increase volume level.
*
Tape deck will not work.
* Is deck in pause mode?
¢ is tape loaded correctly?
* Press PAUSE ( fH } switch to release pause mode.
© Load correctly.
No sound from tape deck.
@ Is TAPE FUNCTION switch selected?
* js a blank tape loaded?
* Press TAPE FUNCTION switch.
© Load a pre-recorded tape.
Recording not possible.
* is tape loaded in Deck I?
| @ Load blank in Deck Hf for recording.
High frequency sounds not
| reproduced.
*° Are heads clean?
® Is a non-Doiby tape being played back with the Dolby
system on?
® Clean heads.
* Turn off the Doiby system.
High frequencies over-
emphasized.
* Is a Dolby tape being played back with the Dolby system
off?
¢ Turn on the Dolby system.
Noise picked up during
recording of tape, record,
radio, etc,
° Is power to TV set turned on?
° Is unit located too close to TV set?
© Turn off TV set.
© Move unit at least 30 cm from TV set.
Stereo Tuner
No sound.
* Is TUNER FUNCTION switch selected?
* Select TUNER FUNCTION switch.
AM reception not possible.
* Is loop antenna connected?
* Is band selector switch set to AM?
* Js station tuned in properly?
* Connect loop antenna.
® Press AM switch.
Tune in station properly.
FM reception not possible.
® Is antenna connected?
* Is band selector switch set to correct position?
* Connect antenna, following instructions on page 4
ructions on page 7,
® Set switch properly, following i
Large amount of noise
* Are radio waves weak, causing antenna input to be insuffi-
cient?
|
* Switch OFF the CD player.
Turntable
Turntable does not work.
* is drive belt properly attached?
* Attach belt correctly.
No sound.
* Is PHONO FUNCTION switch selected?
© Select PHONO FUNCTION switch.
Static, scratching noise pro-
duced.
*® Is record surface dirty?
© Is record warped or scratched?
* Clean record.
* Replace record.
Stylus does not descend at
correct position.
* Is descend position set correctly?
* Is record a special color or size?
* Adjust descent position as explained on page 11.
* Change record or play back manually.)
i
a
UH
<ARB1001>
Advertisement
