Download Print this page
National Public Seating 6010 Series Assembly Instructions

National Public Seating 6010 Series Assembly Instructions

Aristocrat sound floor lectern

Advertisement

Quick Links

TECHNICAL SPECIFICATIONS
Power Output......50W RMS at 10% THD
Mic..........................Electret Condenser Mic (2)
Aux ........................150 mV>220K
Frequency.............100HZ-25KHZ
Response..............+ 3dB
PARTS
A
Right Side Panel
D
Top
(Reading Surface)
Page 1 of 4
ASSEMBLY INSTRUCTIONS
6010 SERIES | ARISTOCRAT SOUND FLOOR LECTERN
ASSEMBLY TIPS
Read the instructions carefully and follow Diagrams
to ensure an easy and correct assembly.
Do not use a sharp instrument such as a Knife or a
Screwdriver to open the packaging, as this may
scratch or possibly damage the unit.
All assembly should be done on a clean protected
surface such as carpet or the like.
Make sure that you have all the required Parts
listed below.
CARE OF YOUR CABINET
All exterior and interior exposed surfaces are
Melamine covered as well as edges in matching
patterned Melamine material.
To refresh the appearance, wipe the surface with
a cloth soaked lightly in furniture oil. Avoid speaker
grill area. Your cabinet will look as good as new.
B
Front Panel
E
Shelf
www.nationalpublicseating.com
Power Supply ... 110-120V ohms DC 10.8 12V
Fuse......................2A normal
Output .................8 ohms
Accessories.........Handheld mic, Gooseneck
C
Left Side Panel
F
Bottom
TOOLS NEEDED
Hammer
Phillips
Screw Driver
1-800-261-4112

Advertisement

loading

Summary of Contents for National Public Seating 6010 Series

  • Page 1 ASSEMBLY INSTRUCTIONS 6010 SERIES | ARISTOCRAT SOUND FLOOR LECTERN ASSEMBLY TIPS Read the instructions carefully and follow Diagrams to ensure an easy and correct assembly. Do not use a sharp instrument such as a Knife or a Screwdriver to open the packaging, as this may scratch or possibly damage the unit.
  • Page 2 INCLUDED HARDWARE INCLUDED ACCESSORIES Non-Locking Locking Cam Bolts Hand-held Gooseneck x1 Casters x2 Casters x2 Condenser Mic x1 Corner Amplifier Cam Locks 1/2” Phillips Tie-Clip Braces x4 Series 700 x1 Screw x36 Mic x1 Figure 1 CAM LOCK ASSEMBLY Proceed by alligning the Cam Bolts with the Cam Locks Insert the Cam Bolts in the Cam Locks until the both Panels are flush.
  • Page 3 ASSEMBLY OF LECTERN DIAGRAM “B” It is important that the instructions on the Assembly are followed carefully. Align the holes on Panel edges with the three Cam Bolts on Panel , tighten Cams by turning clockwise until locked. Next will be Panel and Panel .
  • Page 4 700 SERIES AMPLIFIER OPERATING INSTRUCTIONS OPERATING PRECAUTIONS Before operating the amplifier, be sure you fully understand all instructions and features of the amplifier. DO NOT turn amplifier on until all input and output connections have been made. NEVER replace fuses unless power is o . MICROPHONE INPUT CONNECTION The microphone input accepts 1/4"...