National Public Seating Kangaroo Stool 6722HB Assembly Instructions

Base/Column assembly
1. Insert Glides (A) or Casters (B) into each of the five legs of base (C).
2. Insert column (D) firmly into center of base.
3. Slide footring (F) onto column with ring facing upwards and place at
desired location.
4. Slide column cover (E) over column.
5. Tighten footring knob well to assure that it stays in place. Note:
There is a rubber sleeve in the center of footring. To prevent scratch-
ing of column when tightening knob, be sure that the sleeve is in
place and when tightening be careful to tighten over the rubber
sleeve.
Model 6722HB Kangaroo Stool Assembly Instructions
Seat assembly
1. Align seat mounting plate/backrest arm (I) with screw holes in underside of seat (J).
Loosely insert all four seat bolts (G) through holes on seat mounting plate/backrest
arm (I) into screw holes on underside of seat (J) and tighten only slightly, using the
provided Allen key.
After all four seat bolts (G) are properly inserted, tightly secure them in a crossed
fashion.
2. Once seat mounting plate has been attached to seat, place seat over upper portion
of column and push down firmly.
Backrest assembly
1. Attach backrest bracket plate (M) to rod on top of backrest arm by sliding the rod
into side holes of plate.
2. Place backrest bracket (L) onto top of plate.
3. Hold backrest (K) over bracket and align holes on bracket to holes on backrest.
4. Using the provided Allen key , tightly secure the two backrest bolts (H) to backrest.
1
Page 1