Customer Menu In The Phi 5000 Latte Go / Go - Philips 5000 LATTE GO Service Manual

PHI 5000 LATTE GO / GO+
1.9.

Customer menu in the PHI 5000 Latte Go / Go+

List of default settings
Display
COFFEE
TEMP
STANDBY
DISPLAY
CONTRAST
WATER
HARDNESS
ACQUA CLEAN
FILTER
0/8
Changing the default settings
DISPLAY
CONTRAST
Setting Setting
Coffee
MAX
MED
temperature
MIN
180°
Stand-by
60°
30°
15°
Contrast
4
Water hard-
3
P
2
1
AquaClean
ON
0/8
It is possible to customise the machine functions through the programming
menu. The machine must be turned on and ready to work.
If necessary, refer to the "8.1 List of default settings" chapter.
>
Press the MENU button and scroll through functions list to select the
function whose settings are to be modified:
Note: the images at the side refer to a sample function.
> Press the OK button to select the desired function
Once selected:
Press the UP button to increase the value.
>
Press the DOWN button to decrease the value.
>
Press the OK button to confirm the change.
>
When the change has been implemented, the OK message will be
displayed.
The modified but unconfirmed values will not be stored.
Press the ESC button to exit the programming function.
>
The machine automatically exits the programming mode if no button is
pressed for 3 minutes.
Value
average
15 minu-
time tes
average
4 (very
hard
ness
water)
to be
water
installed
filter
01 INTRODUCTION
Description
Coffee brewing temperature set-
ting.
Stand-by time setting.
Display contrast setting.
Water hardness setting.
AquaClean settings.
8/9