Table of Contents
Advertisement
PLAYING THE ME-6B LIKE A ROW OF PEDAL EFFECTS — THE MANUAL MODE
A "Manual Mode" setting is also stored with each of the
patches in the ME-6B's memory.
The "Manual Mode" is
where you can turn effects on and off by depressing the
Number Pedals
or the Bank Pedal. This makes the ME-6B feel
just like a series of "pedal effect" effects.
The Manual Mode effects setting will be just the way you it
them when you return to it again.
SELECTING THE MANUAL MODE
<Using the Panel Buttons>
Press the [MANUAL] button to switch between Manual Mode
ON/OFF. The MANUAL Indicator will be on while you are
in the Manual Mode.
oBoss
ME-5B
BASS
VALUE 1 BANK
A
MULTIPLE
WRITE:COPY MANUAL
ave
A
VALUE
MANUAL INDICATOR
MANUAL BUTTON
<Using the Footswitch>
When you have a footswitch (FS-5U; optional) connected to
the MANUAL REMOTE jack, you can also use it to turn the
Manual Mode ON/OFF. It works in the same way as using
the panel buttons.
MANUAL MODE OPERATIONS
<<Switching Effects ON/OFF>>
in the Manual Mode, you can switch effects on or off using
the Number/Bank Pedals. When the indicator over a pedal
is lit, that effect is on. The effects are assigned to the pedals
as follows:
_- #8 2
ie
ec!
COMPRESSOR:
ENHANCER
OVERDRIVEY
DISTORTION SYNTH
BASS
EQUALIZER
CHORUS!
FLANGER
*The Noise Suppressor is onall the time, and can't be turned
on and off like the others.
<<Setting and Changing Parameters>>
You can set or edit parameters for any effect in real-time.
Here's how:
1 Select the parameter to be edited.
Select the effect to be edited with the PARAMETER [II]
buttons, and the parameter to be edited with the PARAM-
ETER [4] |] buttons. The exact parameter you will be
editing is beneath the flashing Effect indicator and across
from the lit Parameter indicator. Its current setting will be
shown in the display.
*If you select a parameter for an effect which is currently
turned off, the value in the display will flash.
2 Change the setting with the VALUE [a][v]
buttons.
While holding the [4] button, you can increase the
scrolling speed by pressing the button for the opposite
direction, [¥]}. This procedure works for either button.
Repeat steps 1 and 2 to change other parameter settings.
Advertisement
Table of Contents
