Related Manuals for Relay2 RA621EX
Summary of Contents for Relay2 RA621EX
- Page 1 H A R D W A R E I N S T A L L A T I O N G U I D E RA621EX OUTDOOR SERVICE POINT Doc No.: PRDT-0046 | Version 2.0 | Date 2023-12-13 ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 2 For more information about the RA621EX, please COMPANY HEADQUARTERS refer to www.relay2.com. 1525 McCarthy Boulevard, Suite 209 Milpitas, CA 95035, USA www.relay2.com +1 (408) 380-0031 ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
-
Page 3: Warranty
• Do not put anything on top of the AP. If the AP gets liquid in it, please disconnect the power supply, disconnect all network connections, and contact authorized distributor of Relay2, Inc. ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com... - Page 4 PACKAGE CONTENT - RA621EX 2.4 GHz Detachable Antenna Access Point 5 GHz Detachable Antenna Ground Cable Pole/Wall Mount Kit Screws and screw ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 5 (conrete wall case) B. Fasten mounting base with the screws. C. Slide the AP into the wall mounting plate. ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
-
Page 6: Pole Mount The Ap
Note that the provided band is able to apply from 40 mm to 63 mm diameters of the pole. B. Slide the AP to the mounting kit. Vertical Placement Horizontal Placement ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com... -
Page 7: Lan Cable Connection
Then, connect the LAN cable to the AP. Make sure the cinch nut is set to the connector properly, and is tightened correctly. Antenna Connectors Seals RJ-45 Receptacle and Connector Strain-relief Clip Cinch Nut ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com... - Page 8 There are 4 status LEDs at a side face of the AP. • Power Status • Ethernet Link Status • 2.4GHz Radio Status • 5GHz Radio Status LEDs ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 9 AP up and running State 8: Orange solid Green fast Image upgrade blinking State 9: Orange solid Green solid AP connected Table 1 RA621EX LED booting states ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 10 This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. Operations in the 5.15–5.35 GHz band are restricted to indoor usage only. ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 11 ≤23 dBm EU Declaration of Conformity • We, Relay2, Inc. (1525 McCarthy Blvd., Suite 209, Milpitas, CA 95035, USA) hereby declares that this Smart Access Point is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
- Page 12 (APPENDIX A) DEVICE MANAGER USER INTERFACE Introduction The Relay2 Access Point (AP) starts functioning without preconfiguration under typical network condition. The AP is able to connect to the Relay2 NMS when the following prerequisites are met: • The DHCP server is reachable, and the AP can get an IP address.
- Page 13 Confirm that the Ethernet link is active with the LED at the LAN port or the LED on the AP. • In the case that the AP and PC are connected directly for RA621EX, both nodes utilize the link-local IP address with the 169.254.0.0 network.
- Page 14 E.g., in the case that the AP IP address is 169.254.107.230, then https://169.254.107.230:9999. Note: Relay2 AP is not registered for CA certification, so a warning message for a privacy error could be seen upon the first DM GUI access, like below. Please continue the access.
- Page 15 E.g., MAC address = B4:82:C5:00:7D:DB, S/N = EMP6610100C00617 Username: b482c5007ddb Password: EMP6610100C00617 If login is successful, the initial page, as below, is shown. Figure 4: DM GUI initial page ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 16 DM GUI provides commands, configurations, and diagnosis. Commands By clicking the “+” mark to right of the Commands tab, the list of available commands opens. Figure 6: Commands ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 17 This feature can be used to identify deployed APs easily at the site. Note that LEDs do not show the AP status when this command is active. ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 18 A new configuration will be valid once the reboot is completed. You can leave the parameters empty in case you want to keep the current values. Figure 8: AP configuration ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 19 APN for USIM Auth Authentication mode of network access via USIM (both, chap or pap) (small letters only) Username Username for authentication of network access ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 20 Diagnostics. Note: The results of diagnostics appear in a pop-up window. Please allow pop-ups on this site (IP address) before the execution. Figure 9: Diagnostics ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 21 By clicking “Load Proxy Diagnostics Log” or “Load SCM Diagnostics Log,” the latest results of “Proxy Diagnostics” or “SCM Diagnostics,” respectively, are shown on the pop-up window. The pop-up window page supports “Re-run Diagnostics” and “Re-load Diagnostics” for re-execution. ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
- Page 22 Input the username and password (twice), then click “Apply.” By clicking “-“ on the right, the defined user is deleted. Figure 12: User Management (Add New User) ©2023 by Relay2, Inc. All Rights Reserved | www.relay2.com | (408) 380-0031 | sales@relay2.com...
Need help?
Do you have a question about the RA621EX and is the answer not in the manual?
Questions and answers