Speaker Installation - Bowers & Wilkins 600 3 Series Manual

2. Positioning

Speaker Installation

603 S3
603 S3 is intended to be floor mounted only. For proper stability,
always install the provided plinth, then ensure that the speakers
stand firmly on the floor using the spike or rubber feet supplied.
You may attach the plinth during the unpacking process, following
the illustrations above or the diagrams on the top flap of the
carton.
Warning
The plinth MUST always be used, with the rubber or spike feet
inserted into the plinth. DO NOT insert rubber or spike feet
directly into the cabinet.
603 S3
Important Safety Notice
Sharp spikes, do not touch.
The spike feet are designed to pierce carpet and rest on the
floor surface. Initially, screw the lock nuts onto the spikes just
far enough to leave the nuts floating just above the carpet when
the spikes are resting on the floor beneath. Then, screw the
spikes fully into the threaded inserts in the plinth. If the cabinet
rocks when placed on the floor, unscrew the two spikes that do
not touch the floor until the cabinet rests firmly without rocking.
Finally, lock the nuts against the base and gently tighten the nut
to stop the spike foot rotating. It may be more convenient to
fit and adjust the spike feet after speaker positioning has been
optimised.
If there is no carpet and you wish to avoid scratching the floor
surface, use either a protective metal disc (a coin perhaps)
between the spike and the floor, or use the supplied rubber feet.
Fit the rubber feet and level the cabinet in the same manner as
with the spike feet.
<31mm
<31mm
<29mm
<29mm
<36mm
<36mm
<15mm
<15mm
4