Reset Functions - weiland wienet LAN ER300-GLOBAL User Manual

5.5

Reset Functions

The RST button on the front panel can be used in three different situations:
• Reboot the router: Hold the RST button for less than 4 seconds, the router will be restarted.
• Factory reset – restore the default configuration: Hold the RST button for more than 4 seconds.
The PWR LED turns off and on again. We recommend holding down the RST button for 1 second
after turning on the PWR LED on the front panel.
• Emergency factory reset – If the router is unable to boot up due to the bad configuration, turn
off the router (disconnect the power supply). Push and hold the RST button, turn on the router
and hold the RST button for at least 10 seconds. This will return the configuration of the router
to default one.
It is recommended to back up the settings of the router configuration, prior to performing the
factory reset of the router. Note that resetting of the router reset the whole configuration to the
default state.
CAUTION
It is necessary to use a narrow screwdriver or any other small tool to press the RST button.
NOTICE
Figure 13: Resetting the Router
Table 13: Overview of reset functions
Action
Reboot
Factory
Reset
Wieland Electric GmbH | BA001314 | 06/2023 (Rev. A)
Router behavior Trigger events – options
Turns off and then • Disconnect and reconnect the power.
turns on the router • Press the Reboot menu item in the web interface.
• Press the RST button and hold less than 4 seconds.
Restores the default • Hold the RST button for more than 4 seconds.
configuration and • If it does not help (router does not start at all), turn off the
reboots the router router (power supply). Push and hold the RST button, then
turn on the router and hold the RST button for more than
10 seconds.
Hardware Functionality
20