Led Status Indication - weiland wienet LAN ER300-GLOBAL User Manual

The I/O user interface is intended for processing binary inputs and controlling binary outputs. By
default, the binary output is open, i.e., not grounded. The maximum binary output load is 36 V at
500 mA. The constant current supplied by the binary input is 3 mA.
The functional connection scheme of the binary input and output is shown in the following figure.
Figure 12: Functional Scheme of the Binary Interface
5.4

LED Status Indication

There are LED indicators on the front panel of the router to provide router status information.
Moreover, ETH connector, has two additional LEDs providing information about the port status.
Table 12: LED Status Indication
Caption
PWR
USR
ETH0
ETH1
ETH0
ETH1
Wieland Electric GmbH | BA001314 | 06/2023 (Rev. A)
Farbe State Description
Green On Starting of the router.
Green Blinking Router is ready.
Green Fast blinking Updating firmware.
Green Function of this LED diode can be selected by user.
Green On Selected 100 Mbps bit rate.
Green Off Selected 10 Mbps bit rate.
Yellow On The network cable is connected.
Yellow Blinking Data transmission.
Yellow Off The network cable is not connected.
Hardware Functionality
19