Jabra Engage 75 Mono Quick Start Manual

Hide thumbs Also See for Engage 75 Mono:

Jabra Engage 75 Mono

How do I avoid the humming noise in my headset when using

an Avaya 1400/9400/9500 series desk phone?

When a Jabra wireless headset with a desk phone interface – such as the

Jabra Pro 920, Jabra Pro 9450, or Jabra Motion Office – is connected to the

headset port on an Avaya 1400/9400/9500 series desk phone, a humming

noise may occur when the headset is in use. The level of humming noise

may vary, depending on the speaker volume that is set on the desk phone

and on the Jabra wireless headset.

To avoid the humming noise, there are alternative ways to connect a Jabra

wireless headset to an Avaya 1400/9400/9500 series desk phone by using

the handset port.

Basic audio connection using the Avaya handset port

Follow these steps to connect*:

1. Remove the Avaya handset cable from the handset port on the desk

phone.

2. Connect the Avaya handset cable to the handset port on the Jabra

base.

3. Connect the Jabra phone cable supplied between the Jabra base line

port and the handset port of the Avaya desk phone.

https://www.jabra.ie/supportpages/jabra-engage-75/9556-583-117/faq/73b24ef0-

09d8-4159-85be-93b2bc887a1a

17/08/2023 07:37

Page 1 of 4

Table of Contents

Do you have a question about the Engage 75 Mono and is the answer not in the manual?

Page 1 When a Jabra wireless headset with a desk phone interface – such as the Jabra Pro 920, Jabra Pro 9450, or Jabra Motion Office – is connected to the headset port on an Avaya 1400/9400/9500 series desk phone, a humming noise may occur when the headset is in use.
Page 2 End: Place the handset back on the dedicated handset area on the desk phone. *Ensure the Jabra base setting Open desk phone line when undocked is set to “on”. This will ensure an active link between the headset and the base when lifting the handset off the desk phone, at any given time.
Page 3 4. Mount the Jabra GN1000 underneath the Avaya handset in accordance with the Jabra GN1000 setup guide. 5. Connect* the Jabra GN1000 cable to the AUX port on the Jabra base. How to answer/end calls*: Answer: Undock the headset from the base. Alternatively, while wearing the headset press the Multifunction (answer/end) button on the headset or on the base (product dependent).
Page 4 17/08/2023 07:37 as the selected solution for remote call control. You can find more details in the user manual for the specific Jabra headset. Go to Jabra Support search for and find the relevant user manual for your product. https://www.jabra.ie/supportpages/jabra-engage-75/9556-583-117/faq/73b24ef0-...

9556-583-117