Table of Contents
Advertisement
PAGE
11
WEIDER SPORTING GOODS
STEP
7
[37
5/16" X 5" HEX HEAD BOLT
[40
1/4" NYLON LOCK NUT
142
1/4" X2" ROUND HEAD MACHINE SCREW
51
STOPPER PIN
[Бе 11/2" SQUARE PLASTIC INSERT CAP — |
[58 sa'RouNDPLAsTICINSERTCAP
— |
[Ta 3 1/8" 0.0. X 2" LONG PLASTIC SLEEVE
BUTTERFLY
ASSEMBLY
There
are two Butterfly attachments
with this unit:
а RIGHT
BUTTERFLY
(20) and a LEFT BUTTERFLY (21). Instructions are
given for one and are repeated to assemble the other.
O
Assemble the end with the hole of the 3/4" X 9" BUTTERFLY
PAD
BAR (22) into the large hole in the side and at the upper end of the
Butterfly Frame.
(Assemble this into the side of the Frame which
does not have the welded round tube.) Aligning bolt holes and using
a 1/4" X 2" MACHINE SCREW (42), bolt down through the top of the
Butterfly Frame and then through the Butterfly Pad Bar. Secure with
a 1/4" NYLON LOCK NUT (40).
Press a 3/4" ROUND PLASTIC INSERT CAP (58) into the end of the
BUTTERFLY PAD BAR (22). Slide a 3" X 5 1/2" FOAM ROLLER
PAD (11) onto the end of the Butterfly Pad Bar.
Again a small
amount of liquid dish detergent will help with this assembly.
[ ] At the other end of the Butterfly Frame, there is a large angled hole on the inside of the Frame. Assemble the end of the
BUTTERFLY WEIGHT PIN - 1" X 10 1/2" (23) with the hole, into the large hole on the inside of the Frame.
Using a 5/16"
X 5" HEX HEAD BOLT (37), bolt through the Butterfly Frame and then through the Weight Pin. Assemble a 1/2" X 3"
LONG PLASTIC SPACER (69) onto the Bolt end and secure with a 5/16" NYLON LOCK NUT (30).
L] Press a 1" ROUND' PLASTIC
INSERT CAP (59) into the end of the
"WEIGHT PIN (23). Slide a WEIGHT
STOP (71) over the Weight Pin until
it is against the Butterfly Frame.
C Assemble a 1 1/8" O.D. X 2" LONG
a6
PLASTIC
SLEEVE
(72) over the
Welded Round Tube on the Butterfly
51
Frame.
[] Slide the entire assembly now into
the Welded
Tube
Bracket
on the
UPRIGHT (1).
(0 insert the STOPPER PIN (51) into
end first), making sure the side of the
Stopper Pin that has a raised section
is aligned with the hole in the Welded
Butterfly Round
Tube.
Push
the
Stopper Pin into the Welded Butterfly
Tube until it clicks into place as the
raised section exits the hole.
the center of the assembly (rounded
ў
[] Press a 7/8' ROUND PLASTIC
INSERT CAP (60) into the Welded
Butterfly Round Tube.
C Press a 1 1/2" SQUARE PLASTIC
INSERT CAP (56) into the top end of
the Butterfly Frame.
WELDED TUBE
BRACKET
72
WELDED BUTTERFLY
ROUND TUBE
Advertisement
Table of Contents
