Sharp UA-KCP100U-W Operation Manual page 22

NOTE How to Clean Hard-to-Remove Dirt.
Mild Kitchen Detergent
(only Humidifying tray)
1. Fill the tray half-way with
water.
2. Add a small amount of
1
mild kitchen detergent.
Soak for
30 minutes.
2
3
Rinse off the mild kitchen detergent or the descaling solution with clean water.
NOTE
How to install the
Humidifier Float.
MAIN BODY / BACK PANEL / SENSOR FILTER
Wipe with a dry,
soft cloth.
Remove the
dust gently with
a cleaning tool
such as a vacuum
cleaner.
NOTE
• Do not apply excessive pressure when
scrubbing the Back Panel.
Citric Acid
(available at some drugstores)
2 1/2 cups of water
1. Insert the Humidifier
Float under this tab.
Tab
Humidifier
Float
Cross-Section view
Back Panel (Pre-Filter)
EN-20
100% Bottled Lemon Juice
3 cups of water
3 teaspoons
Soak for 30 minutes.
(When using lemon juice as your
descaling solution, allow for more
soak time.)
2. Insert the tab of the
Humidifier Float into the
hole.
3. Insert the tab on the other
side of the Humidifier Float
into the hole.
How to Clean Hard-to-Remove Dirt.
NOTE
Back Panel
1. Add a small amount of
mild kitchen detergent to
water and soak for about 10
minutes.
2. Rinse off the mild kitchen
detergent with clean water.
3. Completely dry the filter in a
well vented area.
Sensor Filter
1. Remove the Back Panel.
2. Remove the Sensor Filter.
3. If the Sensor Filter is very
dirty, wash it with water and
dry it thoroughly.
with No Pulp
1/4 cup
Back Panel
Sensor Filter