Stand-By And Wake-Up; Focus; Capture And Save Image - Fluke Ti300U User Manual

Ti300U, Ti400U, Ti401U, Ti480U
Users Manual
If the Imager crashes, push and hold
down.
All thermal imagers need sufficient warm-up time for accurate temperature
measurements and best image quality. Warm-up time can vary by model and
environmental conditions. Wait a minimum of 20 minutes if the most accurate
temperature measurement is important to your application. When you move an
Imager between environments with large differences in ambient temperature, allow
for additional adjustment time.
Within 15 minutes after startup, the "≈" symbol shows before the temperature value
on the screen to indicate that the Product is still in the warm-up period, and the
temperature value is only for reference.

Stand-by and Wake-up

When the Product is on, push
In stand-by mode, the screen is off and only
warmed up.
In stand-by mode, push

Focus

Make sure that the infrared energy is correctly directed onto the pixels of the detector. Without correct
focus, the thermal image can be blurry, and the radiometric data might be inaccurate.
To focus with the advanced manual focus system, rotate the Manual Focus Control (h in
until the inspection object is in proper focus.

Capture and Save Image

To capture an image:
1. Focus on a target, see Focus.
2. Pull and release the Primary Trigger (green) to freeze the image. The image is in the memory
buffer for you to save or edit the image.
Now the Imager shows the captured image and a menu bar.
To edit an image, push
Video Analysis.
3. Pull and release the Primary Trigger again, or push
SD memory card and the Imager will go back to the live view.
For the settings of capturing thermal images in different modes, refer to
of capturing fully-radiometric videos, please refer to section
14
Note
Note
briefly to put the Product in stand-by mode.
and the Imager quickly enters the operating state.
F2
. For more information about editing images, see
for more than 7 seconds to force a shut
is available; the Imager remains powered on and
F1
, the image will be saved to the Micro-
Image
Capture Mode;
Figure 2)
Thermal Image/
Mode; for the settings