Cateye Micro CC-6000 Instruction Manual page 13

□ Wheel Magnet/Wheel Sensor Mounting
(Fig. 5)
© Wheel rnagnol
© Screw
© Marking line
@ Wheel sensor
© Sensor wire
© Screw
0 Sensor band, rubber pad
@ Wire clip
@ Marking line
(1) Attach the wheel magnet by clamping the left spokes of the rear wheel as shown in Fig. 5.
(2) Attach the wheel sensor on the rear of the left chain stay with either the 1 mm- or the 2 mm-thick band pad. whichever matches the
tube diameter of your bicycle, as shown in Fig. 6.
Suitably position the wheel magnet and the sensor, referring to Fig. 7.
(3} To adjust the relationship between the wheel magnet and the sensor, align the marking lines as shown in Fig. 7 and make sure there
is about 1 mm clearance between them, as shown in Fig. 8.
—12 —