Beurer 3421880 Instructions For Use Manual page 36

Calling up the measurement memory from standby
When the unit is switched off, the measurements from an analysis are automati-
cally saved. There are 30 memory locations for each user.
x Switch on the control unit with the [ ] button.
x Select your user number by pressing the [U] button. To do so, press the button
repeatedly if necessary.
x Press the [T, S] buttons on the control unit to scroll through the analysis values
or the [V, U] buttons to enter the submenus (e.g. switch to BF, ).
Deleting details
1 Deleting a user and all settings and saved values
x Switch the device on and select your user number by pressing the [U] button.
To do this, press the button repeatedly and confirm with [SET].
x When 0.0 appears on the display, press and hold the [SET] button for 5 seconds
to delete the user.
x Use the [V, U] buttons to select "YES" and confirm the prompt with the [SET]
button. If you do not wish to delete the user, select "NO" and confirm with the
[SET] button.
All saved values and settings for this user are deleted.
2 Deleting individual saved values for a user
x From the "Mem" measurement memory, select a measurement and briefly press
the [SET] button on the control unit to delete the displayed value from the mem-
ory. You can also do this immediately after the measurement has been taken.
x Use the [V, U] buttons to select "YES" and confirm the prompt with the [SET]
button. If you do not wish to delete the value, select "NO" and confirm with the
[SET] button.
3 Deleting all saved values for a user
x Call up the "Mem" measurement memory and press and hold the [SET] button
on the control unit for approximately 3 seconds to delete all the values.
x Use the [V, U] buttons to select "YES" and confirm the prompt with the [SET]
button. If you do not wish to delete anything, select "NO" and confirm with the
[SET] button.
Switching off the scale (standby mode)
x Wait until the display automatically switches itself off after approximately 45
seconds or press the [ ] button on the control unit to switch the display off ma-
nually.
Date and time can still be seen.
Power-saving mode
x Press and hold the Tand S menu buttons simultaneously for 10 seconds. The
date and time disappear.
x To switch back on again, press and hold the Tand S menu buttons simultane-
ously for 10 seconds.
35