PCchips M905ULR 3.2 User Manual page 29

S.M.A.R.T. for Enable this item if any IDE hard disks
Hard Disks support the S.M.A.R.T. (Self-
Monitoring, Analysis and Reporting
Technology) feature.
Floppy Drive If you have two diskette drives installed
Swap and you enable this item, drive A
becomes drive B and drive B becomes
drive A.
Floppy Drive If you enable this item, your system will
Seek check all floppy disk drives at start up.
Disable this item unless you are using an
old 360KB drive.
If you have entered a password for the
Password Check
system, use this item to determine, if the
password is required to enter the Setup
Utility (Setup) or required both at start-
up and to enter the Setup Utility
(Always).
L2 Cache Leave these items enabled since all the
processors that can be installed on this
board have internal L2 cache memory.
System BIOS If you enable this item, a segment of the
system BIOS will be copied to main
Cacheable
memory for faster execution.
SDRAM This item determines frequency of
Frequency SDRAM memory.
SDRAM Timing This item allows you to enable or disable
the SDRAM timing defined by the Serial
By SPD
Presence Detect electrical.
SDRAM CAS# This item determines the operation of
Latency SDRAM memory CAS (column address
strobe). It is recommended that you leave
this item at the default value. The 2T
setting requires faster memory that
specifically supports this mode.
3: BIOS Setup Utility
25