Table of Contents
Advertisement
This loads the standard BIOS default values. To select, highlight it and press
the＜Enter＞ key. Then press the ＜Y＞ and ＜Enter＞ keys to confirm.
Otherwise, press the ＜N＞ key to cancel.
3.9 Load Setup Defaults
This feature loads the setup default values from BIOS default table. To select,
highlight it and press the＜Enter＞ key. Then press the ＜Y＞ and ＜Enter＞
keys to confirm. Otherwise, press the＜N＞ key to cancel.
3.10 Supervisor/User Password
You can assign, modify, or cancel password settings. To modify, highlight
"Supervisor Password" or "User Password" and press the ＜Enter＞ key. The
screen will prompt you ("Enter Password:").
Enter your password. The
maximum size of the password is 8 characters. System will prompt you to
reenter the password to verify. Remember the passwords are case sensitive.
If you want to remove the passwords, either delete passwords or press ＜Enter
＞ when prompting for new password.
If you want it to require password upon initial system startup and upon
entering the CMOS Setup Utility, you will need to change the selection of the
(Security Option) under (BIOS FEATURES SETUP) to "System".
If the setting is "Setup", the system will only require the password you activate
CMOS Setup Utility.
3.11 IDE HDD Auto Detection
If your system has an IDE hard drive, you can use this function to detect its
parameters and enter them into the "Standard CMOS Setup" automatically.
This routine only detects one set of parameters. If your hard disk is formatted
using different parameters than those detected, you have to enter the
parameters manually. If the parameters listed do not match the ones used to
format the disk, the information on that disk will not be accessible. If the auto-
detected parameters displayed do not match those that are used for your drive,
ignore them. Type N to reject the values and enter the correct ones manually
from the Standard CMOS Setup screen.
42
Advertisement
Table of Contents
