Removing The Battery; Disposal Of Batteries - Beyerdynamic MMX 200 wireless Manual

MMX 200 wireless
1. Introduction
In accordance with the Electrical and Electronic
Equipment Act (ElektroG) and the European WEEE
Directive 2012/19/EU, electrical and electronic
equipment must be disposed of separately from
household waste at the end of their life.
If the device is operated with batteries, these must be
removed from the device before disposal. If batteries
are permanently installed in the device, they must be
removed by professional staff for safety reasons.
These disassembly instructions show how to proceed.
2. Information for Germany on disposal
in accordance with the Electrical and
Electronic Equipment Act (ElektroG)
and the WEEE Directive 2012/19/EU
The symbol of the crossed-out dustbin
u
on the product, in the operating
instructions or on the packaging means
that electrical and electronic devices
must be disposed of separately from
household waste at the end of their life
cycle.
Always dispose of used equipment in
u
accordance with applicable regulations.
For the return of old equipment,
u
batteries and rechargeable batteries,
there are free collection points or a free
return to beyerdynamic, as well as other
acceptance points for reuse. The
addresses are available at the local city
or municipal administration.
u Dealers for electronic equipment are
generally obliged to take back waste
electrical/electronic equipment free of
charge. This obligation also applies to
sales via remote communication.
u For further information, please contact
the local authorities or the dealer from
whom the product was purchased.
The consumer/end-user is responsible
u
for the deletion of personal data on the
waste electrical/electronic equipment.

3. Disposal of batteries

Dispose of batteries separately after use
u
from the product in accordance with
applicable regulations. They must not
be disposed of in household waste. The
return is free of charge for consumers/
end users.
Before disposal, discharge and remove
u
the batteries.

4. Removing the battery

Caution:
u
Before removal discharge the battery.
For this product a non-destructive
removal of the battery by the end user
is not possible. Due to the safety risk,
this activity may only be carried out by
professional staff.
Please contact beyerdynamic or consult
independent professional staff.
Discharge battery
u
before disposal.
u To make it easier to
remove the battery,
remove the ear pads on
both sides by turning
them anti-clockwise.
u Loosen the three screws
of the baffle on the
right-hand side of the
headphones using a
suitable screwdriver.
Carefully remove the
u
baffle.
Attention: The cable
of the circuit board is
soldered to the baffle.
3