Making The Connections - Panasonic SA-PMX82M Operating Instructions Manual

Table of Contents

Advertisement

Making the connections

Connect the AC mains lead only after all the other
connections have been made.
Compatible speaker system (sold separately)
Use this unit with a 2 channel speaker system.
(Impedance: 3 ™ - 16 ™)
• Using other speakers can damage the unit, and sound
quality will be negatively affected.
Refer to the operating instructions for the speaker
system for details.
To household mains socket
1
Connect the antenna.
Place the antenna where reception is best.
Tape
(not supplied)
Be sure to fully tighten
the nut.
• If radio reception is poor, use an outdoor antenna (not supplied).
4
2
Connect the speakers (sold separately).
This unit (rear)
To right speaker
2 2
Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so may
damage the speakers.
1
3
Connect the AC mains lead.
Do not use an AC mains lead with other equipment.
Conserving power
The system consumes a small amount of power ( 14),
even when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Note:
• Keep your speakers more than 10 mm from this unit for
ventilation.
• Put the speakers on a flat safe surface.
• When you play at high levels for a long period, it can cause
damage to the system and decrease the life of the system.
• Decrease the volume in these conditions to prevent
damage:
- When you play distorted sound.
- When you adjust the sound quality.
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do the procedures included in these instructions
when you attach the speakers.
Connecting other equipment
You can connect a VCR, DVD player etc.
This unit (rear)
To left speaker
Note:
• Disconnect the AC mains lead before connection.
• Switch off all equipment and read the appropriate operating
instructions.
• Components and cables are sold separately.
• If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adaptor.
e.g. DVD player
(not supplied)
Audio cable (not supplied)

Advertisement

Table of Contents
loading

Table of Contents