Advertisement
Available languages
Available languages
eet
tats PSM
ala
SECURING THE DISHWASHER
The unit should now be ready to slide into the cabinet
1. Drive the mounting screws through the holes in the
opening. To avoid scratching the floor, use floor protection
mounting brackets as shown for Top or Side Mount.
and caution when sliding the dishwasher into the cabinet.
2. After the unit is installed in the enclosure, leveled and
Make sure that the hoses and cords do not bunch up behind
secured, lock the two front leg levelers in place by
the unit or kink as you slide the unit back. Make certain to
driving the enclosed leg leveler locking screws into each
slide the unit into place before raising the leg levelers.
screw slot located in front of the levelers.
3. Tighten screws until they are flush with the surface of the
slots.
For Top Mount - Wooden
NOTE: If the dishwasher is not level, it may not operate
properly and could cause leaks.
a,
Check that the leveling legs are firmly against the floor.
* «
Place a level against the front panel.
*
Check that the dishwasher is plumb. If needed, adjust
leg levelers until dishwasher is plumb.
*
Open the door.
*
Place the level inside against the top of the tub.
*
Check that dishwasher is level from side to side. Adjust
the leg levelers as necessary.
r m{Qmm/ 0.5"
For
Side
Mount
- St
Countert
Adjusting the leg levelers:
or
stereo
one
OURS TIOP
*
To adjust the front feet (X), turn clockwise to raise or
counter-clockwise to lower.
*
To adjust the back foot, turn the center screw (Y)
clockwise fo raise
or counter-clockwise to lower.
10
Advertisement
