Remote Control; Specifications - multicomp pro MP710995 User Manual

Setting of Function Menu
Press and hold the button M4 (menu) for one second to enter the setting interface of function menu.
Press the left and right key to switch into different
for one second. And the instructions of menu settings are as follows:
Function Serial No. Split symbol and
Function Descriptions of Serial Number:
1. External switch control - turn the knob to change the setting, and ON parameter indicates enabling
the external output switch while OFF indicates turning off the external control
2. Connection terminal compensation setting - turn the knob to change the parameter
parameter means turning on the output terminal compensation while OFF means turning off the output
terminal compensation.
3. External setting of analog control setting - turn the knob to change the parameter setting, 0 refers
to turning off this function; 1 means the external analog voltage control, and current value is subject to
fixed setting; 2 refers to the external analog current control, and the voltage value is subject to fixed
setting; 3 means the voltage and current are controlled respectively by the external analog control.
4. The communication baud rate setting - the baud rate can be set to
adjusting the knob.
5. 485 communication mode is turned on - adjust the knob to change the 485 communication mode
(ON or OFF).
6. 485 communication address setting - turn the knob to set 485 communication address.
7. 485 communication format settings - 485 communication format can be set by adjusting the knob.
0: Low-Endian
1: High-Endian
2:Low-Endian data
3:High-Endian
settings. To exit, press and hold the button M4 (MENU)
function code Parameter settings
switch.
setting,
9600, 18400, 39600,
exchange mode
data exchange mode
6

REMOTE CONTROL

All models can
machine and controlled by the remote control.
COM setting
Set up the COM port inside the computer according to the following list:
Baud rate:
Parity bit: None
Data bit:8
• Stop bit:1
• Data pow
Functionality Check
• Run this query command via the terminal
• This should return the identification
and ON
Entering the Remote Control Mode:
• Connect the USB.
• The power supply will automatically connect. After a normal connection, there will be an
audible indication from the power supply
• The panel keys are
Exiting from the Remote Control Mode:
• Close the remote control
• Disconnect the USB from the back.
• The power supply disconnects. You will hear a
• The power supply automatically comes in the panel control mode.

SPECIFICATIONS

115200 by
Note: The specifications in the table below have all been tested in temperature ranging from
25° down to -5° and after being warmed up for 20
Model
Voltage Range
Current Range
Load Regulation
Voltage
Current
be connected to a computer through interfaces USB/RS232 on the back of the
9600,19200,38400,57600,115200
control: None
application,
information: Manufacturer,
itself.
locked, so the power supply can only rely on the remote control.
software.
beep,
minutes.
MP710995 MP710996 MP711005 MP711006 MP711007 MP711008 MP711009
0-30V
0-5A
<0.01%+2mV
<0.1%+5mA
7
such as MTTTY (Multi-threaded TTY).
model name, serial number,
which hints that the remit control is over.