Clarion ARX7370R Owner's Manual page 19

RDS Operations
Switching PTY display language
The PTY characters shown in the display can be
selected from 4 languages (English, German,
Swedish, French).
* The factory setting is "ENGLISH".
1. Press ADJ button [15].
2. Select left or right until "PTY LANG?" is dis-
played using a-selector [2].
*. TUNE Mosc wate =e
«
ANY
Ce
aes » Lowe
: oe 2
j
Lowe
3. Select up or down to select the desired lan-
guage using a-selector [2].
wl? TUNE | at
es
Ponth.
0 oe Ree
ST
4. Press ADJ button [15] to return to radio mode.
Note:
¢ Special characters other than alphabet characters
may not be displayed properly.
Volume setting of TA, emergency
(ALARM) and PTY
You can set the volume of TA, ALARM and PTY
to a desired level.
* The factory setting is "TA VOL 9".
1. Press and hold TA button |10| for 2 seconds or
longer to enter TA VOL ADJ mode.
If the control is idle for 7 seconds after the TA
VOL ADJ mode has been entered, the display
returns to radio mode display automatically.
2. Select up or down to set the volume level us-
ing a-selector [2].
oo
"-_f-i_-~
as > a
mrt a
* The volume remains unchanged if the volume
before the TA, ALARM and PTY broadcasts are
received is higher than the previously set vol-
ume.
If it is lower, the volume changes to the level
set in TA VOL ADJ mode.
3. Press TA button to complete volume set-
ting.
M/S (Music/Speech) function
While receiving speech programme with speech
data and this function is on, this enables you to
set the bass/treble to a constant level so that you
can listen to the speech programme clearly.
When speech is finished, the sound returns to
the original bass/treble adjustment.
"* The factory setting is off.
1. Press ADJ button [15].
2. Select left or right until "M/S ACT" is displayed
using a-selector [2].
hal
pee
3. Select up or down to turn "ON" or "OFF" us-
ing a-selector [2].
4. Press ADJ button [15] again to return to radio
mode display.
Note:
e When you receive speech data with the M/S func-
tion set to "on" while a DSP/EQ such as DPH9300,
DPH7300 and EQH5100 etc. is connected to this
unit, the unit invalidates the DSP/EQ adjustments.
* When receipt of speech data has finished, the
sound quality returns to the original bass/treble
adjustment level or the sound level set on the DSP/
Equalizer.
CT (Clock Time) function
The CT function enables you to display clock time
only when CT data is received.
Press DISP button [6] to switch the display to the
CT indication.
* When CT data is not received, "CT——:-——" is dis-
played.
Note:
e There are some countries and stations where clock
time data are not transmitted. In some areas, the
CT may not be displayed correctly.
ARX7370R/ARX7370RW 17