System Contents - Oneida Air Systems Dust Deputy Low-Pro Plus Manual

System Contents

ID Part number Part description
A SDL250000 Lid Separator
B RGZ000005 5/8 x 40" Gasket
C AHX000035 Latch Hardware Pack
C1 AFS000016SS #8 x 5/8" Thread Cutting Screw
C2 AFW041010
C3 AFL000009 Latch
D AXD000031 2.5" x 36" Hose
E AHA000004 2.5" Elbow
F VFA050015 Metal Grounding Tape
A
C
C1
D
F
you will need the following:
• Phillips Head Screwdriver
• Bucket
• Scissors / Razor Blade
1-800-732-4065
Flat Washer
B
C2 C3
E
• Wet/Dry Vacuum
• Vacuum hose and adapters
(2.5" recommended)
Assembly Instructions
1. Apply the 5/8" Gasket (B) onto the Lid Separator
Qty
(A) along the underside rim as shown in [FIG. 1].
1
Note: The Gasket must be firmly sealed to the lid
1
and should overlap itself around the circumference.
2
There must be NO air leaks for the dust collection
system to work properly.
1
1
1
1
1
30"
2. Secure each Latch (C3) to the Lid Separator (A)
using one Washer (C2), and one Screw (C1) as
shown in [FIG. 2].
Note: Refer to the Optional Grounding Instructions
section prior to this step if necessary.
3. Snap the Low-Pro onto your supplied bucket and
ensure that the Latches (C1) are fully secured.
Note: The Low-Pro will sit loosely but will seal
firmly under vacuum pressure.
B
FIG. 1
C1
C2
C3
FIG. 2